floppy3.5
GitHub link: https://github.com/bigcrimping/floppy3.5
floppy3.5 is a battery powered 3.5" floppy disk WiFi NAS. It reads photos from the floppy disks of old digital cameras like the Sony Mavica, shows them on a web page over WiFi, and can copy them to a microSD card so you can keep shooting on the move.
It reads any FAT12 1.44 MB HD disk, showing the files in the root folder on the web page with the option to archive them to the SD card.
How it works
slimline 3.5" drive ──26-pin──▶ RP2354A ──SPI──▶ ESP32-S3 ──WiFi──▶ browser (floppy.local)
controller bridge └──▶ microSD (/DISKnnnn/)
Both processors live on one custom PCB. The RP2354A controller runs a port of the Greaseweazle firmware, with the flux engine reworked to use the RP2354’s PIO and DMA in place of the STM32 timers, so you can also drive it with the gw tool over the secondary USB. The ESP32-S3 bridge talks to the controller over a custom SPI link, decodes the disk and serves the photos on a web page. Both processors are OTA updatable from the web page.
Each disk is saved to its own /DISKnnnn/ folder, because cameras restart their file numbering at MVC-00001 when a disk is erased. Files are compared by SHA-256 so photos already on the card aren’t copied twice.
History
The first prototype used an ESP32 development kit, a Greaseweazle-type adapter board and a desktop floppy drive:
The current design puts the two processors, the LiPo charger, fuel gauge, RTC and power supplies on one PCB, targeting a slimline drive:

The PCB was kindly subsidised by PCBWay, I would have used them anyway so was very happy for their support
The screen
A 1.9" IPS LCD is drawn to look like a segment display, with unused segments and icons showing as light “ghosts”. It shows WiFi setup, a QR code for the web page, read progress with a live track map of all 80 cylinders, and the read result.

Four buttons drive it: READ reads the disk, SAVE reads (if needed) and copies everything to the SD card, DISP returns to the home screen, and POWER turns it on and off.
Housing
The 3D printed housing is two halves held together with M2.5 screws into heat-set inserts, with the PCB sitting on top of the drive. The 3MF files include a paint line so you can print the front band in a different colour.

Build it yourself
The repository has everything needed to build one:
- Hardware: Gerbers, schematic and assembly drawing in
hardware/ - Housing: STL and 3MF files in
mech/ - Firmware: RP2354 controller (pico-sdk), ESP32-S3 bridge (ESP-IDF) and a bring-up self-test in
firmware/, with prebuilt binaries on the Releases page
Other parts needed are a Sony MPF920-type 26-pin slimline drive, a 606090 1S LiPo with NTC, an ST7789 170×320 LCD module and a microSD card. The full parts list, build steps, WiFi setup and quirks are in the README.
Everything in the repository is released under the Unlicense (public domain).
